3.50 HXFX signal out of phase when splitting signal path - new issue to 3.5?

[maxm17]

Hey all. Anyone else having this issue? Don't feel like this was happening prior to 3.50.

Using HXFX in mono (left (mono) main out to FX loop).

Create a separate signal path in HXFX.

No matter where the split signal path returns to the "main" signal path, it clearly sounds out of phase.  Unusable. Doesn't matter if there is an effects block in the split signal path or not. 

 

I looked in the bug database and did not see anything. 

 

Any idears? 

 

Thanks! 

 

[datacommando]

On 2/16/2023 at 11:40 PM, maxm17 said:

No matter where the split signal path returns to the "main" signal path, it clearly sounds out of phase.

Hi,

 

Just a guess, but select the point where the Path B signal returns to the Path A. It’s actually a mixer block and you should check that (page 2) the option to invert the polarity of Path B is set to Normal.

 

See the HX Effects 3.0 Owner’s Manual - Rev C - English - Page 38 - Mixer Settings > Page 2 > Knob 2 > B Polar

 

https://line6.com/data/6/0a020a411710a6112a67116f0b/application/pdf/HX Effects 3.0 Owner's Manual - Rev C - English .pdf

 

Hope this helps/makes sense.

[maxm17]

On 2/16/2023 at 4:08 PM, datacommando said:

Hi,

 

Just a guess, but select the point where the Path B signal returns to the Path A. It’s actually a mixer block and you should check that (page 2) the option to invert the polarity of Path B is set to Normal.

 

See the HX Effects 3.0 Owner’s Manual - Rev C - English - Page 38 - Mixer Settings > Page 2 > Knob 2 > B Polar

 

https://line6.com/data/6/0a020a411710a6112a67116f0b/application/pdf/HX Effects 3.0 Owner's Manual - Rev C - English .pdf

 

Hope this helps/makes sense.

 

Great advice. Will give a try! :) Thanks much.