Analog Bypass Being Triggered by Incoming Audio When Connected to a Computer

[DarfnageL]

I'm currently running into an issue where if I have my HX Stomp connected to my MacBook Pro with Logic Pro open and a track enabled with the HX Stomp set as the input, any audio into the HX Stomp then triggers the "Analog Bypass! Press Any Switch." prompt and no audio is passed. If audio is continuing, pressing a switch will briefly go back to the main page and audio will pass before the analog bypass is triggered again. Disconnecting from USB or quitting Logic Pro will resolve the issue, but it means I cannot record using the HX Stomp at this time. 

 

I have currently gone through a number of troubleshooting steps.

 

I have:

tested with multiple USB cables, issue persists

Tested with the MacBook Pro on a power adapter or battery, issue occurs with both

Reset to factory settings and restored my presets, issue persists

Reset to factory settings and did NOT restore my presets, issue persists

Updated HX Edit, the HX Stomp, and Logic Pro, issue persists

 

Currently I am running MacOS Ventura 13.0, Logic Pro 10.7.7, and the latest firmware for HX Edit and the HX Stomp. 

 

Any help or insight would be greatly appreciated. 

[kduck]

Very strange.  Maybe check to make sure that Logic isn't sending a MIDI CC #70 message.

[DarfnageL]

On 3/20/2023 at 9:31 AM, kduck said:

Very strange.  Maybe check to make sure that Logic isn't sending a MIDI CC #70 message.

 

You are awesome, I had already gone through my midi settings in logic but I checked again and was looking for anything left that might still be sending messages. I had an old sample pad controller that was sending messages over #70.

 

Removed it, and I'm back in business. Saved my butt there! Thank you!