Issue with snapshot assignment to footswitches - fw 3.60

[paoloquaglino]

I just upgraded my Helix Floor to fw 3.60.00

I assign 3 footswitches to the first 3 snaphots, and I see the footswitches displays update accordingly.

I save the preset.

Then, when I push one fswitch to change snapshot, the 3 fswitches displays show "SNAPSHOT^"

It's like if snaphots assignments to footswitches is "snapshot dependent".

So the same footswitch recalls 2 different snapshot, depending on the snapshot I actually activated.

I'm not sure which firmware was loaded before the update, but I'm pretty sure it was not working like this.

I tried factory reset, I programmed directly the helix and through HX Edit, it'is the same
 

Seems more like a bug than a feature, very uncomfortable because I have to program the assignments for every snapshot of a preset.

Old presets, recovered from the backup, work as before

 

Any hint? Maybe it's just a setting somewhere? Thanks a lot, I'm going crazy...

[Schmalle]

It's a feature and it's AWESOME. It enables switching between snapshots in Footswitch mode. You need to set the footswitch for each snapshot.

You can run through snapshots like 1->2->3->1 or 1->3->2->1. Or use two footswitches with 1->2->1 and 1->3->1.