jfman Posted December 18, 2025 Share Posted December 18, 2025 Just bought a catalyst cx 100. Turned it on and the amp selection knob is not moving through the amps. Is there something I need to do first before being able to select through the amps? Quote Link to comment Share on other sites More sharing options...
rd2rk Posted December 18, 2025 Share Posted December 18, 2025 Perform a Factory Reset: Factory Reset In the event that you want to return your Catalyst amplifier to factory settings, follow the steps below. 1. It is highly recommended that you first use the Backup/Restore feature found in the Catalyst Edit software to create a backup of your custom presets and settings —see page 11. 2. Exit Catalyst Edit and disconnect your amplifier from the computer. The following step will erase any and all edits you have made to your presets, effects, etc. in the amplifier. You did make that backup, right? 3. Hold down the CH B and MANUAL buttons on the front panel of your Catalyst while powering on the amplifier. If you haven't already, DL the Catalyst Manual and at least skim it. Quote Link to comment Share on other sites More sharing options...
jfman Posted December 18, 2025 Author Share Posted December 18, 2025 Did this. No change Quote Link to comment Share on other sites More sharing options...
rd2rk Posted December 18, 2025 Share Posted December 18, 2025 If you bought it at a store with a returns policy, return it for an exchange. If not, contact support. It may be a known issue with some units. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.