lauwing

Yes, I want those parameters assigned to footswitch not affected by snapshot (acting like a block with snapshot bypass disabled). Is that intended to have snapshot affecting parameters assigned to footswitch?

I discover on my hx stomp with 3.01 that 1) snapshot is changing parameters assigned to footswitch. I.e. amp drive assigned to footswitch 1 but also affected when changing snapshots. 2) I also experienced that the block on/off status was not updated on the hx stomp screen when the block is toggled on and off, either by physical switches or in HX Edit. Issue resolved after reboot. thanks

Thanks. I thought that maybe the case. So your helix behaves the same in 3.01? Where can I open a ticket?

I might have been confused by the snapshot bypass thing. What I wanted to achieve is to let the Footswitch 1 parameters not affected by snapshot changes. thanks

For example, 1. Footswitch 1 assigned to toggle Amp Drive min: 5 max: 10, so that it works as a drive switch 2. When I am in Snapshot 1, I click Footswitch 1, now Amp Drive is set at 10 3. Then I want to switch to Snapshot 2 during a song to turn on additional Delay and Reverb, but when I saved Snapshot 2, Amp Drive was at 5. However, I want to keep the drive setting at 10 when switching Snapshot. I have to tap Footswitch 1 again to set Amp Drive back to 10. I wonder if there is a setting that allow Snapshot mode bypassing those settings? Just like it can bypass a block's on/off state? I know I could just use a drive pedal instead of changing the amp drive parameter, but then it will occupy a block and more DSP in the HX Stomp. thank you