pederlyng

I am fully aware how the main outputs work - i just draw attention to the fact that when you connect a TRS jack to the main out left/mono output, the TS carries the summed signal, and the TR is silent. If the thread starter has used a split cable (as I tried to at first) this could explain why one channel is silent ...

A cable with a TRS jack in one end and splitted into two TS jacks will only carry the left channel when connected to main L/Mono output. Maybe this is what VioletaCasaubon experiences ?

That is how it works when you drive your amps dirty channel input harder: more drive/distortion and no audible increase in level. Do this instead: Activate the effecs loop in your PG preset and place your volume boost there. Then connect the effects loop of the PG to the effects loop of your Super Crush. Now you are boosting the signal AFTER your amps preamp ...

I connect my PG to my studio monitors (sub with 2 x RCA connectors, passes signal on to 2 x desktop monitors). Cable with TRS jack goes into Main Out Left (mono) and splits into two RCA-connectors, that go into sub (left/right). But I get only left channel - right channel is silent. Do I need a cable with a TS jack into PG ? I am aware that I will get a mono signal out of the PG. Manual isn't clear on this, I think ...

YouTube videos have their own volume-controller as well - haven't they ? I use it always when I play YouTube music from Mac to PodGo ...

I do what you do: I play music from Mac to PodGo. I use the 'Music' app, it has its own button for controlling playback level

You have problably checked this already, but I'll mention it anyway: I have bought a few presets, and they all had the vol pedal set to zero by default. That is, when you switch to a preset, there is no sound - until you physically move the vol pedal ...

I play both acoustic and electric through my Pod Go. I have made separate presets for my Hummingbird and a smaller parlor acoustic, both with L.R.Baggs Element piezos. I use the 'studio preamp' and EQ to dial in the tone and level - and chorus, reverb, and delay in different combinations (snapshots). No IRs - and directly into to PA - great tone :-)

The 4 snapshots within any given bank share the same amp and effects. You can switch effects on / off and change amp and effects settings - but you cannot swap amps or effects within those 4 snapshots. For that you'll need another bank ...

Super, thanks - I will ask Thomann to get me one as well.

Please let us know if Thomann can supply the original Line 6 psu. I would like to have a spare ...

Thomann have several psu's that may work - for instance https://www.thomann.de/dk/joyo_jp_03_power_supply.htm I believe that 2000 mAh is enough? The Myvolts psu might work as well - you'll just need an adapter to reverse the output polarity ...

Be aware that the psu in the link is 'center positive'. Pod Go requires a psu with 'center negative' ...

I know how to access the 2 and 4 models - i just pointed out, that if you aim to create a 'kill switch' effect, you'll have to consider carefully where to put the 'blank'. E.g. if you assign the 'blank' to position 5, it can't be used when the Alt. Tuning knob is engaged ...

You can store 5 presets in each bank - but the JTV-59 switch is 3-way. Have this in mind, if you want to create a 'kill switch' effect.