kensayers

I was hoping that I could use PowerCab edit through the L6 Link from my Helix. I have the USB connection to the Helix and have limited usb ports available. Is it possible to connect to the PowerCab with the Edit software through the Helix? Ideally, I'd have the HX Edit and PowerCab Edit on one machine and one USB connection.

The 000 Flat preset was in the FRFR voicing. I switch to LF Flat and it sounds much better. I also tried LF Raw and it sounded better. I saved it to with the LF Flat voicing. The manual seems wrong as it says there are three voicings: " Voicing - Selects the final post-processing EQ and crossover settings for the speaker system. - FRFR - Uses the high-frequency compression driver with a flattened frequency-response EQ for full-range operation - LF Solo - Uses only the woofer with no EQ applied, allowing it to be utilized like a typical guitar speaker - LF Flat - Uses only the woofer with a flattened frequency response EQ. This voicing is used for the Speaker Mode " This doesn't make any sense. First of all there is no "LF Solo". FRFR sounds like either LF Solo or LF Flat on my powercab as it doesn't seem to use the high-frequency compression driver. LF Flat sounds like what they call FRFR above. LF Raw sounds a lot like LF Flat. Are there updates to the manual available. Your response got me what I needed. Thanks so much! Ken

I tried the following with the associated results: - Helix with cab models into powercab on FRFR mode via L6 Link - sounds very muffled - Play music from my computer through helix into powercab on FRFR mode via L6 Link - sounds very muffled - Play helix without cab model into powercab on speaker emulation mode via L6 Link - sounds very bright - Play music from my computer out of headphone jack into powercab on FRFR mode via L6 Link - sounds muffled - Play music from my computer out of headphone jack into PA speaker via xlr inputs - sounds fine - Play music from my computer out of headphone jack into powercab on FRFR mode via xlr inputs - sounds muffled - Play music from my computer out of headphone jack into powercab on speaker emulation mode via xlr inputs - sounds bright It seems as if the FRFR is not flat at all. It lacks all highs. I tried to take all the other variables out. Please let me know if I need to raise a support ticket or if there is something else I may be doing wrong. Thanks Ken