alinesku

Hi, I need advice for the folowing. From Reaper DAW I need to control two devices through midi. The chain is: Laptop with Reaper > USB midi cable tha goes into POD HD500x midi in > midi out/thru that goes in midi in to Digitech GSP. I can control both by sending to my HD500X only CC commands (and it works just fine, I tested it) and by sending by Midi Out/Thru to Digitech GSP only PC commands. Now, what I need is to bypass and prevent any PC changes to my HD500X. In other words, how can I do for may HD500X to respond only to CC and not to PC midi commands ?

It worked ! Thank you very much !

Thank you! I'm at half way now, I presume :) I assigned both delays to the same FS, it alternates them, everything is fine. I kinda tripped at assigning the mix of both delays to the same expression controller. I put a volume pedal after the amp and before the two delays in my chain, I guess it is corect, isn't it ? Then I tried to assign the mix of each delay to the EXP2 but maybe I do something wrong on mix max and min because it still does not work properly. I will try again. The problem I found is that only my EXP2 is active, I cannot assign anything on EXP1, the pedal does not do anything. Strange, only my EXP2 led is active while my EXP1 led is off forever, I cannot make it work.

Hello friends, I need help with the following issue: I have one song with two different delays in it. My chain is: AMP -> DIGITAL DELAY -> PING PONG DELAY -> MIXER 1. I start my song with both delays off 2. Then I need Digital Delay ON and Ping Pong Delay OFF as I play the song 3. Then I need Digital Delay OFF and Ping Pong Delay ON at the same moment with a single FS press 4. Then I need Digital Delay ON and Ping Pong Delay OFF at the same moment with a single FS press 5. Then I reverse to both delays off How can I do that with SINGLE FS PRESS, especially for 3 and 4 stages of the song ? Regards, Alin.

Hi ! I understant that FBV Shortboard is the best board available and perfectly compatible with Rack Unit Line6 POD HD PRO X. But, after all, what about FBV Express MKII ? Is it not fully compatible ?

Hi So is it possible to output XLR into the mixer/PA and at the same time to output 1/4 into my cab ? The trick is to manage to have the cabinet activated on HD patch chain and at the same time, for monitoring into stage cabinet to have it deactivated on the patch chain. Is it doable ? Regards