Hi All,
First time poster here so please be gentle. I'm also going to get in early and apologise for the bad forum etiquette of two topics in one post but until i receive an approved post this is the only one i get today.
I have just received my Helix and been working through it to put together a configuration that works for me. currently i'm using snap/stomp and using 'mode' to see 8 stomps at once. pressing preset up/down together to see 8 snapshots.
Briefly, I am planning on running the Helix as my single user interface to control :
- Internal Helix effects,
- Effects loop pedals,
- A separate dB11 effects loop extender (midi controlled)
- Bias FX on iPad (midi through usb)
- Onsong on iPad (midi through usb)
So my first question is,
Is there any way to 'bank' through stomps within a preset? As it is possible to load many more than 10 stomps in a single preset, i was hoping there might be a way to cycle through pages of these using the FS1 and FS7 but i can't find it.
The second question is a little more convoluted.
I have midi commands set up through command centre to trigger from FS8-11 and named these (being careful to remove all other assignments from these FS) and that works great to control Onsong through usb midi (previous/next song, scroll up/down). What has thrown me is that if i press 'Preset up and down' together to display snapshots on all 8 FS, i find that the midi commands in FS8-11 are still triggered as i select a snapshot from that row. I was hoping that the snapshot would suspend the momentary midi program change commands under these 4 switches and then re-enable them for use once the snapshot is selected.
Has anyone else come up against this and found a solution?
