Search the Community
Showing results for tags 'layers'.
Found 1 result
Hi All, First time poster here so please be gentle. I'm also going to get in early and apologise for the bad forum etiquette of two topics in one post but until i receive an approved post this is the only one i get today. I have just received my Helix and been working through it to put together a configuration that works for me. currently i'm using snap/stomp and using 'mode' to see 8 stomps at once. pressing preset up/down together to see 8 snapshots. Briefly, I am planning on running the Helix as my single user interface to control : - Internal Helix effects, - Effects loop pedals, - A separate dB11 effects loop extender (midi controlled) - Bias FX on iPad (midi through usb) - Onsong on iPad (midi through usb) So my first question is, Is there any way to 'bank' through stomps within a preset? As it is possible to load many more than 10 stomps in a single preset, i was hoping there might be a way to cycle through pages of these using the FS1 and FS7 but i can't find it. The second question is a little more convoluted. I have midi commands set up through command centre to trigger from FS8-11 and named these (being careful to remove all other assignments from these FS) and that works great to control Onsong through usb midi (previous/next song, scroll up/down). What has thrown me is that if i press 'Preset up and down' together to display snapshots on all 8 FS, i find that the midi commands in FS8-11 are still triggered as i select a snapshot from that row. I was hoping that the snapshot would suspend the momentary midi program change commands under these 4 switches and then re-enable them for use once the snapshot is selected. Has anyone else come up against this and found a solution?