None of this helps my unit at all. Brand new, straight out of the box, fresh downloads of Line 6 drivers - all first time stuff... Started the update, hit 50% in moments and froze there for about 10 minutes and then the HX Edit told me that the update failed and I needed to power the unit down, close the Edit and start over again. I did all of that and my Helix LT is stuck with the following code in the upper left corner of the display: :-7 and a message that reads "Updating UI MCU Firmware, please wait. Do not power off the unit!" When I read the message shown me via HX Edit about update failure and what-not, it took me a few minutes to decide to follow those instructions, given that the Helix told me to not turn it off... Anyway, the unit is stuck as-is and NOTHING will change it. The Line 6 drivers will not recognise it when connected and the display will not change. What the hell is going on with this $1200 piece of lollipop and how the hell do I fix it?!?!?
I even tried the "Helix/HX Update Doesn't Work? Look Here!" bit and NOTHING changes / everything stays the very same as I've described above.
H E L P !
