jamcoops

Glad you got in and fixed it. Mark

Now I have got in I must say I am not surprised that the board has come loose. It is just a friction fit on four stanchions. These stanchions are threaded like the ones you get in a PC for the Motherboard but no screws have been used. I will source screws for mine to stop it doing it again! Mark

Hi all, I have worked it out. You need to lever off the front cloth grill. There is snap connectors in each corner. Just get something thin and strong down the sides near the connectors and you can lever it loose. Be careful not to damage the edges though. Mark

Hopefully someone will answer this becasue I have the same problem. This is the second one of these where the processor unit has come unglued. The first one was brand new so swapped straight away by the dealer. I've had this one over two years now though. As I have two would really like to know how to do this myself without having to take it to Milton Keynes for an expensive repair. Thanks, Mark

Hi Phil, Thanks for that. Stupidly I hadn't tried it direct on the unit, which actually works as it should. It still doesn't work when using HX Edit to assign in the first instance, but, I am happy now. Thanks for the quick response. Mark

Hi all, I'm running a wet dry set up. the Wet amp is a Bluguitar AMP1 and the dry is a Powerstage SD170 using two Victory Preamps (Kraken and Countess). Now, for some reason the Kraken has an inverted polarity on the crunch channel (really annoying!!!! but not the HX's fault). Therefore, I need to tell the HX mixer to change this setting when I change Snapshots. My issue is that it will not save the command, nor it seems any other command in the mixer. I've tried assigning to a foot switch but that will not save its setting either per snapshot. Am I being thick or is there a bug here? Oh, and does anyone know if Line 6 are likely to come out with a fix for the instant commands working the ExtAmp switching? Really annoying using four of my switches up. Many thanks, Mark