zeropluszero

No one huh?

Looking into one of these HX one devices, I think get it's uses and limitations, but wondering if this could be cabled and work.... If I wanted the HX One to replace say a tuner, noise gate and a delay, can the pre/post effect and cabling work that I could cable the HX One physically at the start of my chain to use tuner and input noise gate, then send out to other pedals and the preamp, then cabled into the amp FX loop, return to the HX, use say a delay, then back to the FX loop return? Or is that too greedy? I'm assuming this can't be done, but would be cool if that is possible.

So like everyone else today, I went to update to 3.7 today. I opened HX Edit, backed up all the presets & my IR's and went on my way. I wanted to factory reset to see if there was any new factory presets - maybe there is, maybe not, thats cool, I wanted to revisit what was there anyway. Anyway so I went to reimport my IRs. I only have 40 or so of them, and frankly barely use them, but I selected all of them in my PC and then just...dragged them into HX edit, and it just worked. I was really expecting to have to do them individually. Thanks to whoever coded HX Edit. I was expecting it to be a pain, and someone out there had already thought of the easiest way to do something and it just worked.

Just wanted to add my piece so someone can find it - I just did the above mentioned comment from Codamedia - I have a Hotone Ampero Press I had wanted to use as expression using a Y-Split to allow me a single button FS - Using a TRS-TRS cable directly from the Stomp to the Expression port on the Ampero Press worked as I wanted, and it would go 0-100 properly. I needed to connect the Y cable to the Output port to get the same thing to work, otherwise it was doing the 0-100-0 thing when plugged into the expression port.