brishaban

How did you make out with the service center? I have an old 300 and it's changing models on it's own. B

I too am looking for a standard to make a lefty conversion as my last Franken-Variax was from a 300 to a Peavey EXP. B.

Looks like hot glue

Thanks for all the responces. So...as pointed out I guess what I'm referring to is different input volume levels. On some patches using the guitar input the patch is either extremely low or (for the sake of argument) normal. Some Variax could also be low or normal. (is there some page I'm missing that switches patches to variax only or guitar only? I've had many different guitar processors (Line 6 XT Live, Roland VG99 and others) and while there is some difference in input volumes there's always some way to level the playing field so to say. I'm looking to say go to patch 1A, plug in my Strat and have it be X level. Disconnect and then plug in my Variax 500 and it be nearly the same or at least have some way of "normalizing the input gain structure. I will try the input 1 to Guit-Var-Aux and input2 to AUX method but I guess the only other issue I have is using the editor Varix alway defaults to Tyler. Is there a global setting to set all patches to Variax, 300, 500, 700? Best to all, Tekman

I just picked up a Pod HD500X and patch levels are all over the place. Some patches work only with my Variax 500, some work with both the 500 and my Strat but usually the output volume for the Strat is much lower than the variax. Before I started I reset the HD, updated all soft and firmware on both the HD and my computer. I've set input 1 to guitar and auto for impedance and input 2 for Variax. I'd like to set the HD500X so it's output from all patches are similar in volume (I understand that bringing in a compressor, eq, or other modifier bight boost or cut some levels) I'm just looking for a starting point for each patch. I'd also like to match the levels going into the HD500X from the Varian to my Strat. How is everyone else doing it without bending down every patch change to adjust either output volume and or master volume? Any guidance would be most helpful. Tekman