Search the Community
Showing results for tags 'mission sp1-l6'.
Found 2 results
-
I'm only 2 days into owning my Stomp XL and Mission SP1-L6H and am slowly getting the hang of it. Today I dove into learning how to setup the SP1 pedal. I thought I had it, but ran into an issue I can't figure out. I bought a preset online. Using HX Edit, I added a wah to that preset and it works great. Then I created a new preset from scratch and added a wah to it, but the "position" parameter doesn't change when the SP1 is on and I move the pedal. Then I created a new preset with nothing but a wah on it, but the "position" parameter still doesn't change. Global Settings > Preferences Exp/FS Tip: Set to "EXP 1" Exp/FS Ring: Set to "FS8" Global Settings > Footswitches FS7 Function: Set to "AllBypass" FS8 Function: Set to "TogglEXP" Wah Block Preset Settings (same for all 3 mentioned above) Wah: Conductor Bypass: Footswitch 1 Position: EXP Pedal 1 I'm clearly missing something, probably something very simple, but haven't been able to figure it out, even after a few hours of internet searches and video watching. Seems like it must be related to some difference between the preset I bought versus the two that I created. I'm happy to provide any additional info needed if anyone is up for helping me figure this out. -
I have had the above pedal in use with my Helix LT for about 9 months. Regardless of foot position I have had issues when going heel down, where the pedal gets notchy in the last segment to <heel fully down> and makes smooth control impossible. I adjusted it using the supplied allen key as per this video (tightening and loosening) with no impact. https://www.youtube.com/watch?v=qfSbCYsFQJs A local, long time expert amp and pedal repairer has cleaned the rack, also with no effect. He suggested that a pot replacement may be the go. The supplier in Melbourne, Australia has no pots, expressed doubt that the pot replacement is the issue and recommended I contact Mission for suggestions. Has anybody had similar experience and any suggestions as I would prefer not to have to freight it across Australia?
