Search the Community
Showing results for tags 'signalchain'.
Found 3 results
-
Hi folks, Santa (or my daughter, lol) bought me a Pod Express Bass for Christmas. I am running a very small pedal board and the Pod Express will allow me to dip my toe into an all-around effects pedal to try some things out. My question: Where to put the Pod Express Bass in my signal chain? Right now, this is the signal chain I am running (see attached picture): Two basses via cable into a Radial Bigshot I/O so I can hot swap basses between songs Into a very basic Donner footswitch tuner From the tuner into a Tech 21 SansAmp, which either goes to our band FOH system or to the venue FOH system via XLR. I am thinking of dropping the Pod Express in AFTER the tuner but BEFORE the SansAmp. Thoughts? Advice? Many thanks! Paul Our band: https://thealteredegos.com/
-
My sound system is mono. In my signal chain, I still want my delay and reverb to be post amp and cab. If I use the mono output (L), will my delay and reverb automatically collapse into mono or am I only get half the signal on those post amp effects? Alternatively, I could add a compressor to the end of the signal chain but I don't always want to use up an effect block just to get a mono signal. Any recommendations?
-
Hi guys, I just wanna know if I in the same preset can send some of the effects of the preset through the fx loop and others through the line output to the amp at the same time using the HX Effects. Thanks Pedro
