rhandy Posted June 6, 2017 Share Posted June 6, 2017 Hello I have one "old" setup Marshall JMP1 Pre Amp and Marshall 8008 Power Amp + Marshall 1922 Cab (2x celestion GT-T75). I connect outputs from Pod to Marshall Power Amp. I use output Combo Power Amp setting, but all presets sound muddy and too digital.If I use 4 cable method and use JMP1 as Pre-amp and pod only for effects on Fx Loop, sound good.I have to remove cab simulation and amp and use only pre-amps simulators? Quote Link to comment Share on other sites More sharing options...
BillBee Posted June 6, 2017 Share Posted June 6, 2017 Have you tried running the HD Studio Direct then to the power amp? GT75s should respond well and IMO Studio Direct opens the HD up. That said every setup is a bit unique and you should play around with what sounds good to your ears. Quote Link to comment Share on other sites More sharing options...
rhandy Posted June 6, 2017 Author Share Posted June 6, 2017 HI! I don´t try in Studio Direct. I will try today! Thank You! Quote Link to comment Share on other sites More sharing options...
rhandy Posted June 8, 2017 Author Share Posted June 8, 2017 Combo power amp works. But the best way to start is choose one blank preset, start only one amp, test different cabs, adjust settings on amp. Some amps have very low output to my power amp, compared to Marshall JMP1 preamp. I have to opern master gain and increase some Dbs on mixer. Quote Link to comment Share on other sites More sharing options...
BillBee Posted June 8, 2017 Share Posted June 8, 2017 That is the way to learn the HD start small and build. For low output amps try adding a TS block in the chain with the Level High with 0 gain to throw some signal at the amp sim. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.