Jagman13 Posted July 3, 2018 Share Posted July 3, 2018 (edited) I cannot seem to be able to assign snapshot automation... to track automation. If I click on track automation and select 1 Helix Native I can only select Knobs1-16 and switches 1-12 (Screenshot HXN Snapshot assignment missing options) enclosed below. There is no other options as described in the Pilots Manual on page 38.. (Enclosed image HXN Pilots snapshot assignment below). Do I need to to set up any controls knobs or switches prior to these option appearing or should the appear normally? Or as very possible.. I am missing something very obvious? :/ Thanks for any advice or guidance.. Jagman.. Edited July 3, 2018 by Jagman13 Quote Link to comment Share on other sites More sharing options...
Jagman13 Posted July 3, 2018 Author Share Posted July 3, 2018 Just noticed this was reported in an earlier thread and was supposed to have been fixed in 1.6... seems its not... :/ Quote Link to comment Share on other sites More sharing options...
soundog Posted July 3, 2018 Share Posted July 3, 2018 Yeah, that's a big bad bummer. It's listed now as a "Known Issue" in the new V1.6 release notes. See this thread (July 3 post, not the earlier ones) for the Smart Control workaround: Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.