Please can someone help me with an issue I have about Mono and stereo with my line 6 HX effects

[bassmin31477]

Basically what I want to know is can I route mono effects to only be used on one amplifier with a speaker attached but then also run only stereo effects stereo through two amplifiers so that only my stereo effects run stereo through both amps and my motto effects run mono through one amp?????

[rd2rk]

Assuming a full sized Helix, you can take a split before the stereo effects, run that out whichever pair of outputs you want for Stereo. The Mono effects on the other split will collapse the signal to Mono, which you can take out the Mono out (Left) of the other pair of outputs.

 

Guitar -> Helix In -> Split -> Mono FX -> Left Mono Out -> Mono Amp

                                            -> Stereo FX -> L/R Out -> Stereo Amps

[rd2rk]

9 hours ago, rd2rk said:

Assuming a full sized Helix, you can take a split before the stereo effects, run that out whichever pair of outputs you want for Stereo. The Mono effects on the other split will collapse the signal to Mono, which you can take out the Mono out (Left) of the other pair of outputs.

 

Guitar -> Helix In -> Split -> Mono FX -> Left Mono Out -> Mono Amp

                                            -> Stereo FX -> L/R Out -> Stereo Amps

 

My bad! Asleep at the wheel. Codamedia replied (in another deleted thread?):

 

"Insert a SEND Block before the stereo effects

The send goes to your mono amp

The L/R outputs is your stereo outs to a pair of amps."