bverdon Posted October 9, 2021 Share Posted October 9, 2021 I like topology III for clean tones and topology II for crunch and heavier tones on my Helix / DT50 setup. I know I could build a new patch but... is there any way to switch the topology within the same snapshot? Thanks Quote Link to comment Share on other sites More sharing options...
phil_m Posted October 9, 2021 Share Posted October 9, 2021 Within the same snapshot? You can assign the Topology parameter to a controller just like any other parameter. So you could toggle back and forth between two settings with a footswitch if you want. Quote Link to comment Share on other sites More sharing options...
bverdon Posted October 9, 2021 Author Share Posted October 9, 2021 What?! This would be awesome... how do I do that?? ok... went back and I see where I can do this... now to see if I can save a clean snapshot with one topology...and the dirty tones with a different topology within the same snapshot...that would be ideal vs. switching via stomp mode. Thank you!! Quote Link to comment Share on other sites More sharing options...
bverdon Posted October 9, 2021 Author Share Posted October 9, 2021 Ah... well.. by assigning the topology to a footswitch.. now I can save the desired topology per snapshot within a given patch! Nice! Did not think I could do this... love it! Thank you very much Phil! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.