SenorSpanky Posted January 12, 2022 Share Posted January 12, 2022 Hi there - long time Line 6 user, new poster... I recently purchased a Helix LT and PowerCab Plus 112. What I'm trying to do is set up all my patches so they could be used with any of the following: * XLRs would have cab sims/IRs. * Headphone out is monitoring the XLRs (already found and set this in global settings) * Digital - goes to Powercab through L6 link. No cab sims * 1/4" outs - might run into a poweramp and guitar cab, so no IRs/Cab sims I have the split path thing down, but can only choose 2 paths, each with a target output. So I can set up path 2A with no cab sims going to Digital and path 2B going to Multi, or just XLR, but then I don't have a way to specify which one 1/4" uses... And when I specify 2A is digital and 2B is XLR, I'm still getting the non-cab sim'd setting into headphones, even though I specified that phones monitors XLR in the global settings. Am I missing anything? I searched on YouTube and through this forum a bit and can't find anything definitive. Am I just exceeding the capabilities here? Quote Link to comment Share on other sites More sharing options...
rd2rk Posted January 13, 2022 Share Posted January 13, 2022 Path 2A no Cab Sim to Digital. Path 2B with Cab Sim to XLR. Before the split, place a send and use it to connect to your amp/cab instead of the main 1/4" out. If HP are set to monitor XLR, everything before the split will be in your HP. The same signal will be going to 2A as to 2B. I would think that's what you want. Am I misunderstanding the problem? 1 Quote Link to comment Share on other sites More sharing options...
SenorSpanky Posted January 14, 2022 Author Share Posted January 14, 2022 I just want Digital and 1/4 (or send) with no cab sims. XLR and headphones with cab sims. Right now, when I try to do that with the split the Digital/no cabs signal is getting mixed with cabs signal in my headphones and sounds half good/half terrible. Does that help? Hope I'm explaining it right. I can try the split/send option. That's a great idea. Thanks. Quote Link to comment Share on other sites More sharing options...
rd2rk Posted January 14, 2022 Share Posted January 14, 2022 If you've configured the preset as I described with HP set to monitor XLR you should be hearing what you're asking for. Attach your preset and I'll test it to see where you're going wrong. Quote Link to comment Share on other sites More sharing options...
SenorSpanky Posted January 14, 2022 Author Share Posted January 14, 2022 Thanks! Will get that to you sometime tomorrow. Quote Link to comment Share on other sites More sharing options...
SenorSpanky Posted January 17, 2022 Author Share Posted January 17, 2022 The Send before the split was exactly what I needed. Thanks! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.