Using HX Effects to send momentary command in snapshots?

[stugatzo]

Hi all.

Just got the new Boss IR-2 to add to my HX Effects board.

For background, I know how to use command center and have successfuly used it to trigger MIDI changes and amp channel changes in the past.

However, I have figured out through trial and error that that only signal the IR2 accepts from the HXFX to make it switch between the red and green (A/B) channels is a "momentary" pulse (as opposed to latching).

So my question is this: Is it possible to program an instant 'momentary' command out of the HXFX via the ext footswitch ports when using snapshots?

So when i switch from Snap1 to Snap2 (for example), it immediately triggers a mode change (red to green or green to red) on the IR2.

Thanks in advance!

 

[Schmalle]

On 1/16/2024 at 2:32 PM, stugatzo said:

I have figured out through trial and error that that only signal the IR2 accepts from the HXFX to make it switch between the red and green (A/B) channels is a "momentary" pulse (as opposed to latching).

Check again because the Boss manual indicates that the CH SEL input is for latching switches.