HXFX Help Needed, Assign a footswitch to control a parameter

[MWolfkiel]

I am trying to set up the following:

 

FS 6 is set to my Para EQ. What I want to do is step on FS 6. and increase the Level (for leads), then step on it again and bring it back to the original level. 

 

I know it is possible, I had it once before, but lost that preset and cannot figure out how to do it. I can get to the point where I set min and max levels for Level, and when I press FS6, I get the volume boost I want BUT when I press it again the EQ turns off instead of returning to the minimum level I want. I tries using the manual and youtube c=vids but always seem to end up at the same point. 

 

Can anyone please tell me, step by step, how to achieve this. A million thanks.

[datacommando]

On 7/20/2024 at 7:29 PM, MWolfkiel said:

I am trying to set up the following:

 

FS 6 is set to my Para EQ. What I want to do is step on FS 6. and increase the Level (for leads), then step on it again and bring it back to the original level. 

 

I know it is possible, I had it once before, but lost that preset and cannot figure out how to do it. I can get to the point where I set min and max levels for Level, and when I press FS6, I get the volume boost I want BUT when I press it again the EQ turns off instead of returning to the minimum level I want. I tries using the manual and youtube c=vids but always seem to end up at the same point. 

 

Can anyone please tell me, step by step, how to achieve this. A million thanks.

Hi,

 

You might want to read this post regarding “lead boost” settings

 

 

Hope this helps/makes sense.