Community: Message List

Re: Getting activated UX1 to work with Pod Farm 1.12, Logic OSX Snow Leopard

support@line6.com — Sat, 09 Feb 2013 00:39:09 GMT

Oh well, thank you. I think I'll go with the iLok version. I appreciate the help.

Re: Getting activated UX1 to work with Pod Farm 1.12, Logic OSX Snow Leopard

support@line6.com — Fri, 08 Feb 2013 00:39:58 GMT

Actual, TheRealZap, where can I find the upgrade? Or am I just required to buy the full version? Ideally I would use the UX1 as a dongle in hopes of using PodFarm with both computers. Thank you.

Re: Getting activated UX1 to work with Pod Farm 1.12, Logic OSX Snow Leopard

support@line6.com — Fri, 08 Feb 2013 00:37:30 GMT

Thank you, at least now I know the problem!

Getting activated UX1 to work with Pod Farm 1.12, Logic OSX Snow Leopard

support@line6.com — Thu, 07 Feb 2013 23:49:33 GMT

Hello,

I have an old UX1 that I am trying to get up and running with Pod Farm 1. I used to have Pod Farm working with my Pod X3 that I ended up selling to a friend. Now I am missing Pod Farm and trying to get it to launch as a plugin on Logic 9 with Snow Leopard.

Monkey and License Manager are both saying that both computers I've tried this on (MacBook Pro and MacPro) as is the UX1 device, but I am unable to get it working with PodFarm.

Stand Alone mode is working fine.

I would love to get this working as an easy way to start working on demos. Thank you.

Re: X3 Bean Input/Feedback Problem

support@line6.com — Thu, 18 Feb 2010 11:28:47 GMT

It appears it was just a ground loop from using generator power with a power conditioner. Hopfully plugging in to real power will help keep the problem from happening again. Thanks a lot!

Re: X3 Bean Input/Feedback Problem

support@line6.com — Sun, 14 Feb 2010 10:27:11 GMT

I think this might have worked. I don't have access to a guitar right now but tomorrow I will check it out. With just a cable it didn't seem to have the same high pitched squeal. So hopefully this will be the end to my problem. Thank you so much!

X3 Bean Input/Feedback Problem

support@line6.com — Sun, 14 Feb 2010 06:59:54 GMT

Today I hooked up my X3 that has served me well for almost a year and had a strange feedback like hum whenever the guitar was plugged in. First I made sure the noise gate was on and turned all the way up. It turned the volume of the noise down but it was definitely still there.

Then I tried using different cables and guitars. I changed the cable from the guitar into the pod and the cable from the pod to my recording interface. The noise was still there. It is even there when I am playing and it is just as loud, unlike any feedback I have ever encountered before. I listened through headphones to confirm that the problem was indeed the input and not my output or my digi rig.

I really want to solve this problem. Tomorrow I am going to try going Guitar>DI Box>XLR in>Pod but I would rather avoid adding extra components in my signal chain. To make it worse my 1 year warranty ends on February 27 and I am on tour with my band past that date. Not having the pod working is really hindering our abilities to demo our new record.

I am also supposed to be recording a few bands right when I get home and I'd much rather use my pod than actually putting a mic on a cab.

Please help me figure this out so I'm not out in the cold on this situation.