Community: Message List

Re: Good experience with 2 issues

support@line6.com — Mon, 29 Oct 2012 22:59:36 GMT

I think I better keep an eye out for this bump...........

Re: Recording all channels, Monitoring Some channels and some channels to Main Out at One Time

support@line6.com — Fri, 19 Oct 2012 00:52:12 GMT

The way I understand this, and I may be wrong. Is that the M20D recorded signal is taken just after the gain trim setting on each input channel, and before any of the processing happens.

So, if you set the trim correctly for each channel, it doesn't matter what you do with the rest of the settings on the channel, ie the EQ, Gates, FX, Track mutes, ect. The recording is already done by the time the audio signal gets there. This is why each input channel recording is dry (without processing).

This means that you can mute all the channels from the main outs or monior outs if you want. Those tracks will still get recorded on each separate track. They will not however be recorded on the Stereo Mix Track, since that recording is taken from the Main Outs. Basically whatever you hear coming out the main outs, is what will be recorded on the L&R Main Mix.

I'm pretty sure that the monitor mix doesn't doesn't matter to either the individual channel recordings or the main mix recordings, so you can set up the monitor mix however you want.

So, to do what you want, just mute any channels that you don't want to hear in the main outs. Keep in mind that they will also not get recorded on the 2 track main mix tracks either since they are muted. They will however be recorded on the separate track recordings.

Re: Mute FOH Keep Monitors and Recording

support@line6.com — Wed, 26 Sep 2012 01:43:46 GMT

Any help would be greatly appreciated.

Mute FOH Keep Monitors and Recording

support@line6.com — Mon, 24 Sep 2012 18:24:39 GMT

I have my new M20D setup in our bands small rehearsal space. I want to run all instruments through the mixer so we can record, but I don't need to send everyone through the mains. That would make for a very loud reheasal.

How do I mute channels in the main outs, but keep them going to the monitors and recording?

Also, does anyone know if there any plans to develop a M20D app for the PC?