Community: Message List

Re: My beloved m13 decided to die.

support@line6.com — Sun, 02 Dec 2012 19:47:47 GMT

Thanks!

Re: My beloved m13 decided to die.

support@line6.com — Sun, 02 Dec 2012 17:11:41 GMT

Reflashing didn't solved the problem. Service center it is then.

Where can I mail it? There's a service center a few hours from me but I honestly don't trust them.

Re: My beloved m13 decided to die.

support@line6.com — Thu, 29 Nov 2012 15:27:45 GMT

I'll be trying that during the weekend. Fingers crossed! :(

Re: My beloved m13 decided to die.

support@line6.com — Tue, 27 Nov 2012 01:37:26 GMT

Well, I just tried to adjust the contrast, it's just holding setup and moving the 2nd knob on 4th fx, and the contrast does change but still no letters on the display.

Here's a pic:

http://i16.photobucket.com/albums/b29/V8KillerTSi/20121126_213121.jpg

Re: My beloved m13 decided to die.

support@line6.com — Mon, 26 Nov 2012 22:40:30 GMT

Well, actually no since I can't read the displays. However, I did remember how to do a factory reset and did it but even after that there was no change on contrast.

Maybe if you can post the instructions on how to get to the contrast setting I can try it.

Re: My beloved m13 decided to die.

support@line6.com — Mon, 26 Nov 2012 20:49:31 GMT

I''m using one of those cheap craftsman multimeter.

Yeah I though that since it's AC output the internals should be fairly simple and there's no rectifier inside the power supply.

Primary side voltage was 120v when I was doing the tests.

I opened the M13 yesterday and moved a bit the ribbon cables to see if there was any change on the displays but no luck. I didn't disconected the ribbon cables because they have a spot of glue on the sides and I haven't checked if I have warranty but my guess is I don't since I got it on the street and owner have no proof of purchase.

Re: My beloved m13 decided to die.

support@line6.com — Sun, 25 Nov 2012 19:52:07 GMT

I just verified the output voltage on the power supply and it is 11.6vac. Maybe under load(connected to the m13) it drops to 9v? If anyone can check the output voltage on your power supply please let me know your reading.

Thanks

Re: My beloved m13 decided to die.

support@line6.com — Sun, 25 Nov 2012 17:48:12 GMT

Here's a picture of the problem:

http://i16.photobucket.com/albums/b29/V8KillerTSi/20121125_133015.jpg

My beloved m13 decided to die.

support@line6.com — Sun, 25 Nov 2012 17:29:19 GMT

I used my M13 about a week ago on a gig and decided to use it again today to play around with the harmonizer. I turned it on and and I get nothing on the displays, like if the contrast is set back to 0. I performed a factory reset but still nothing.

Re: Quick questions about M13 Fx loop

support@line6.com — Mon, 12 Nov 2012 00:40:54 GMT

Got it! Thanks!