Community: Message List

Re: Problem authorising POD Farm 2.51

support@line6.com — Wed, 07 Mar 2012 14:59:24 GMT

I'm having the same problem...and I only bought my UX1 today!!! It says on the box 'free upgrade to podfarm 2" and "free FX junkie model pack" which I fail to see anywhere either.

I get a Error message when I open Pod Farm 2.51 saying "entry point not found" What the hell?? HELP

Re: UX1, Studio Monitors, Music help

support@line6.com — Tue, 06 Mar 2012 17:56:16 GMT

Hi, I have another question...

There is only one jack for the monitors...I have two active monitors Left and Right...how do I connect them both and be able to pan left/right durring mixing etc?

Thanks.

Using the HD Pro's Cab Sims

support@line6.com — Thu, 23 Feb 2012 15:48:12 GMT

Hi there folks.

I am using a Pod HD through a custom Valve Power amp. My question to you is...How can I use the Pods Cab sims through a normal 412 cab without it sounding awful like it does at the moment?

I know that going direct into a PA works well in this situation, but my Peavey JSX cab refuses to give me any good sounding Cab sims. I want to use the V30 sim.

Would the best thing for me be to get a Line 6 cab?

Thanks for any info on this

Re: When switching patches, can I get the WAH already activated without having to hit the toe button on the FBV?

support@line6.com — Sun, 27 Nov 2011 13:27:07 GMT

J. H. CHRIST....why didn't I think of that!!! I will try it when I'm at the rehearsal room on Tuesday. I'll let you know how it went....thanks a million dude

When switching patches, can I get the WAH already activated without having to hit the toe button on the FBV?

support@line6.com — Sat, 26 Nov 2011 20:59:41 GMT

Hi there,

I have a question about the POD HD PRO, but first I'd like to give you a scenario.

I use an FBV Express MKII to change to patches within a bank, the A, B, C, D and Volume work fine. The WAH works fine when I hit the TOE BUTTON, which means it is communicating properly with the POD HD unit.

Let's say for argument sake that my main distortion is in patch A and again in patch B only this time it has WAH in the chain.

When I switch over from A to B I would like to have the WAH activated already so I don't need to hit the TOE BUTTON.

I was able to do this with my XT Live, but can't seem to find any reference to it this time round in the POD HD instructions.

So, Is this even possible or am I stuck with having to hit the TOE BUTTON each time I want to use the WAH when I have WAH in my effects chain?

Right now I can hear the WAH effect in the patch ready to go, but to be able to control the sweep I have to push the TOE BUTTON first which is a pain.

Please help.

Thank so much.

Gareth.