http://line6.com/support/index.jspa?view=discussions Most recent forum messages en Sat, 26 Jan 2013 18:41:53 GMT Jive SBS 4.5.7.0 (http://jivesoftware.com/products/clearspace/) 2013-01-26T18:41:53Z en http://line6.com/support/message/408629?tstart=0#408629 <!-- [DocumentBodyStart:6fade132-b62a-4532-82bf-66d68cbbb08e] --><div class="jive-rendered-content"><p>Thanks - if you mean turn the VOL FX on in the FX window of Edit, then yes, it's on - no change.</p></div><!-- [DocumentBodyEnd:6fade132-b62a-4532-82bf-66d68cbbb08e] --> Sat, 26 Jan 2013 18:41:53 GMT support@line6.com http://line6.com/support/message/408629?tstart=0#408629 2013-01-26T18:41:53Z 3 months, 3 weeks ago 0 http://line6.com/support/message/408624?tstart=0#408624 <!-- [DocumentBodyStart:fc39ad93-7719-4e65-9f89-fc8fe19c0abc] --><div class="jive-rendered-content"><p>POD HD500 with firmware level 2.10</p><p style="min-height: 8pt; height: 8pt; padding: 0px;">&#160;</p><p>My built-in volume pedal (EXP-2) stopped working after I temporily assigned it to control reverb level.&#160; The unit is now outputting 100% volume independent of the pedal position.</p><p style="min-height: 8pt; height: 8pt; padding: 0px;">&#160;</p><p>I've tried re-assigning the volume pedal EXP-2, and calibrating the pedal per posted instructions - no effect.&#160; Tried the same with EXP-1 - no effect.&#160; I've also tried a factory reset, again no effect.&#160; One post says the pedal can become disconnected from too much pressure, but I don't think this is the case, the problem seemed to follow the assignment to reverb level.</p><p style="min-height: 8pt; height: 8pt; padding: 0px;">&#160;</p><p>Any help would be greatly appreciated, thanks.</p></div><!-- [DocumentBodyEnd:fc39ad93-7719-4e65-9f89-fc8fe19c0abc] --> Sat, 26 Jan 2013 18:11:36 GMT support@line6.com http://line6.com/support/message/408624?tstart=0#408624 2013-01-26T18:11:36Z 3 months, 3 weeks ago 2 0