Community: Message List

Re: Same volume level for all patches! How do I do this?

support@line6.com — Sun, 12 Feb 2012 01:42:47 GMT

Okay!

I'll try this too.

Thanks a lot,

Paulo

Re: How to set parameters values to assign control?

support@line6.com — Sat, 11 Feb 2012 21:28:43 GMT

Hi!

I have already knew I could use the expression pedal to control the parameters.

I'll try to learn about the midi!

Thank you,

Re: Same volume level for all patches! How do I do this?

support@line6.com — Sat, 11 Feb 2012 21:20:09 GMT

Thanks a lot!

I'll try it.

Best regards,

Paulo Guilherme

How to set parameters values to assign control?

support@line6.com — Sat, 11 Feb 2012 14:23:26 GMT

Hello people!

How are you?

I've always used equipment from boss and now I'm using the POD HD 500 and I am very pleased with the tones. In my boss gt-10, I'd like to address "pedals assigns" values, for example, I could increase or decrease the drive, or feedbak (delay) in pre-determined values (change the drive from 50 to 80, for example .)

How to do it in POD HD-500? I would like, for exemple, when stepping into the switch FS1 change the drive value parameter from 40 to 60.

Is this possible?

Thank you.

Best Regards,

Paulo Guilherme

Same volume level for all patches! How do I do this?

support@line6.com — Fri, 10 Feb 2012 19:08:52 GMT

Hi all!

How are you?

Well, I wold like to know how can I set all my patches in same volume (output).

If the Line6 POD Editor had a VU meter, I think it will be easier.

Thanks a lot,

Paulo Guilherme