http://line6.com/support/index.jspa?view=discussions Most recent forum messages en Thu, 11 Oct 2012 06:59:51 GMT Jive SBS 4.5.7.0 (http://jivesoftware.com/products/clearspace/) 2012-10-11T06:59:51Z en http://line6.com/support/message/394950?tstart=0#394950 <!-- [DocumentBodyStart:669c3fab-cd15-49a2-a093-0f35169d6e20] --><div class="jive-rendered-content"><p>Thank you Merlin... the problem is solved. It was the setup issue. I set the input 2 to "same" and the problem is solved. I should have checked that earlier. Thanks once again.</p></div><!-- [DocumentBodyEnd:669c3fab-cd15-49a2-a093-0f35169d6e20] --> Thu, 11 Oct 2012 06:59:51 GMT support@line6.com http://line6.com/support/message/394950?tstart=0#394950 2012-10-11T06:59:51Z 7 months, 2 weeks ago 0 http://line6.com/support/message/392855?tstart=0#392855 <!-- [DocumentBodyStart:838ec25d-283a-4912-9033-46a13c31fe0d] --><div class="jive-rendered-content"><p>Hi, </p><p>Its been about 2 months that I bought my HD 500 and I have noticed that the amps on the dual amp setup doesn't sound the same when I turn one of them off. I had setup 2 treadplates and I wanted to check the sound of both of the amps individually so I turned amp A off, but then when I try to edit the sound of amp B there is no Drive even when I turn the drive knob all the way to 100. Is this normal? or is there something I am not doing it right? But when I turn off amp B, I get the the full sound of amp A. Also I have put the pan L and R to 0 in the mixer for both the amps. Please help.. I want to know if this is an issue with the unit, or if its me. </p></div><!-- [DocumentBodyEnd:838ec25d-283a-4912-9033-46a13c31fe0d] --> Sat, 29 Sep 2012 04:10:37 GMT support@line6.com http://line6.com/support/message/392855?tstart=0#392855 2012-09-29T04:10:37Z 7 months, 4 weeks ago 2 0