Community: Message List - How to calibrate hd pod 300

Re: How to calibrate hd pod 300

support@line6.com — Tue, 18 Dec 2012 17:22:37 GMT

You also have to "enable" the wah in the patch or it won't work no matter how hard you mash on the switch.Not all patches have the wah enabled.

How to calibrate hd pod 300

support@line6.com — Sat, 10 Dec 2011 18:57:58 GMT

Hi thre guys!

I'm trying to calibrate my hd pod 300, but after see these video http://www.youtube.com/watch?v=dg2cJ0QNDeA, I still have a probelm. Which one is the pedal toe switch?? I did as the video ask me to do, but nothing happen

Plus!

If I use the pedal volume and push till the the wah doesn't work.

I'm new with this stuff, so

And advice???

Thanks Very Much

Re: How to calibreate hd pod 300

support@line6.com — Tue, 13 Dec 2011 12:56:09 GMT

POD HD 300 & 400 pedal calibration:

-After performing a manual reset on the unit press the D channel footswitch

-Press down on the expression pedal until the switch clicks

-Push the expression pedal fully to the heel down position

-Press the D channel footswitch

-Push the expression pedal fully to the toe down position

-Press the D channel footswitch

-Sweep the pedal to check the values (should be from 0 to 127 for full sweep)

-Press the D channel footswitch to save

if needed, please stand up and use your body weight to actuate the pedal toe switch

line6antonio

Re: How to calibreate hd pod 300

support@line6.com — Sun, 11 Dec 2011 13:38:02 GMT

You need to apply a LOT of pressure to activate the toe switch until it loosens up. You usually can't do it sitting down - need to stand on it.

Re: How to calibreate hd pod 300

support@line6.com — Sat, 10 Dec 2011 19:01:02 GMT

Like a Crybaby....Line 6 toe switches can be a little stiff when new...put some wieght on it...It should break in after a bit...