Community: Message List - FBV shortboard MKii calibration problem

RE: FBV shortboard MKii calibration problem

support@line6.com — Mon, 05 Mar 2012 11:43:13 GMT

Hello. We haven’t heard back from you, so we're going to assume your question has been answered. If it has been answered, please consider awarding points to whoever was helpful and/or answered the question so they get the formal recognition.

In the event your issue has not been resolved, we have generated a support ticket for you so we can continue to communicate. Should you need further assistance, please respond to the ticket. With us talking via the ticket, I will mark this thread answered.

Q: What is a support ticket?

A: A support ticket allows you to directly correspond with a Line 6 Support Representative. An email will be sent to you from Line 6 containing a link to the ticket when a Line 6 Support Representative responds to it. Please follow the link in the email to view your open ticket to work one on one with Line 6 Support. Also, in your account, click My Account, then click Support Tickets to view the support ticket. Here’s a shortcut: http://line6.com/account/tickets/view/.

Please note: Sometimes support ticket notifications will be filtered to spam and junk folders. If you did not receive an email from us indicating that a ticket has been created, please make sure to check those folders in your email host, and also that your email account is receiving messages at all. You may also consider adding Line 6 to your safe senders list.

Re: FBV shortboard MKii calibration problem

support@line6.com — Wed, 29 Feb 2012 12:48:17 GMT

hello

please use these directions:

FBV Shortboard Mk. II

-Hold the D button while connecting the CAT-5 cable on the FBV. The display will read “CALIBRATE PEDAL” until the D button is released, at which point it will read “1 PEDAL TOE”.

-Press and hold the internal pedal toe-switch until the LCD changes to “2 PEDAL MIN”. This should occur instantly.

-Set the heel to (minimum) position, press the D button. The LCD will change to “3 LCD MAX”.

-Set the toe position (maximum) and press the D button. The LCD will change to “CHECK VALUE 127”.

-Move the pedal and verify that the value reaches 0 in the minimum position and 127 in the maximum position.

-Press D to exit

if this does not help, please contact your Line6 dealer

line6antonio

FBV shortboard MKii calibration problem

support@line6.com — Sat, 25 Feb 2012 23:49:24 GMT

Hi - I have a POD HD desktop and just purchased a FBV shorboard MKii. However the volume does not work and I followed the calibration procedure but the display reads "CHECK VALUE 0" after calibration no matter if the pedal is in max or min position. I have tried to reflash the firmware. Any suggestions or is the board broken?

(The same result happen if I connect using USB to computer or CAT5 to POD HD unit)