Community: Message List - Is it just a Fuse?

Re: Is it just a Fuse?

support@line6.com — Fri, 16 Mar 2012 15:52:58 GMT

+1 to fflbrgst. But, to answer your question about how to access the fuse; you may need to carefully use a small "flathead" screwdriver for leverage to open that panel (it pops out). The power circuit fuse is in there.

Re: Is it just a Fuse?

support@line6.com — Thu, 15 Mar 2012 13:27:18 GMT

If the fuse was blown, it would not power up at all.

First, try a factory reset - hold the A (or Clean) button in while turning on the power and hold it for 5-8 seconds.

If this doesn't work, you shoudl be able to bring the amp back to where you bought it for exchange - most stores have a 30 day return policy. If not, you will need to bring it to a Line 6 Service Center for evaluation.

Is it just a Fuse?

support@line6.com — Thu, 15 Mar 2012 07:15:25 GMT

I turned on my spider iv 30 today, and it didnt work. after leaving the power switch on for it to warm up, mutiple lights came on the front panel

3 red amp model lights at the same time and one of the effect dial lights as well. i'm hoping this problem is just a blown fuse? i noticed on the back of the amp

under the power cord plug , there is a little panel with a picture of a fuse on it. i tryed looking in the manual to see how to access the fuse with no luck???

somebody please help i've only had this amp for 2 weeks..