http://line6.com/support/community/support/legacy/amps/ax2?view=discussions Most recent forum messages en Sun, 02 Sep 2012 16:00:28 GMT Jive SBS 4.5.7.0 (http://jivesoftware.com/products/clearspace/) 2012-09-02T16:00:28Z en http://line6.com/support/message/389830?tstart=0#389830 <!-- [DocumentBodyStart:2c8a4575-f015-4b63-b036-fa105cc8b467] --><div class="jive-rendered-content"><p>First try a hard reset. You lose all of you presets - but this is the first thing you should always try when these amps go screwy. And you should be bakcing your stuff up using midi anyway. If that doesn't work - then It needs to be serviced. Take to a Line 6 service center. I had one do this that was unrepairable according to the service center. They didn't charge me and they pretty much tried everything. I have it in my garage fo parts in case my other AX212 goes bad. Good Luck.&#160; </p></div><!-- [DocumentBodyEnd:2c8a4575-f015-4b63-b036-fa105cc8b467] --> Sun, 02 Sep 2012 15:58:01 GMT support@line6.com http://line6.com/support/message/389830?tstart=0#389830 2012-09-02T15:58:01Z 9 months, 2 weeks ago 0 http://line6.com/support/message/389814?tstart=0#389814 <!-- [DocumentBodyStart:23bdac34-c411-4ac9-9fbf-4e62e7023078] --><div class="jive-rendered-content"><p>This has never happened to my AX2 212. When the power is on the display says err and the amp makes a light popping sound. Any suggestions? It seems to be stuck in a loop. The display goes through a series of presets and scambled numbers over and over.</p></div><!-- [DocumentBodyEnd:23bdac34-c411-4ac9-9fbf-4e62e7023078] --> Sun, 02 Sep 2012 13:47:02 GMT support@line6.com http://line6.com/support/message/389814?tstart=0#389814 2012-09-02T13:47:02Z 9 months, 2 weeks ago 1 0