Community: Message List - HD500 can I have a setting with an amp model ... but turn off just the preamp and only use a power amp and cabinet model

Re: HD500 can I have a setting with an amp model ... but turn off just the preamp and only use a power amp and cabinet model

support@line6.com — Fri, 21 Sep 2012 14:12:16 GMT

No it can't, even though it would be very nice to split all of that and be able to also split the speaker also so you can place effects right after the preamp and before the power amp.

Re: HD500 can I have a setting with an amp model ... but turn off just the preamp and only use a power amp and cabinet model

support@line6.com — Thu, 20 Sep 2012 23:12:18 GMT

i don't think it can be done. the full amp section' models the pre and power amps. but who knows, i've been wrong before. this will be the second time

HD500 can I have a setting with an amp model ... but turn off just the preamp and only use a power amp and cabinet model

support@line6.com — Thu, 20 Sep 2012 21:44:23 GMT

I have a preamp set up I would like to use and not be colored by another preamp, but I would like to go out of the POD direct to a PA (or recording) so i would like to have an amplifier Power Amp model and a cabinet/mic model in the sound

Can this be done on the HD500

Thanks