Community: Message List - HD400 - Amps not working at all

Re: HD400 - Amps not working at all

support@line6.com — Wed, 12 Dec 2012 12:55:46 GMT

Yep, power ON while holding down D Footswitch to Initiate Pedal Calibration procedure.

Video tutorial is here --> http://line6.com/support/docs/DOC-2044

Re: HD400 - Amps not working at all

support@line6.com — Wed, 12 Dec 2012 09:23:55 GMT

****UPDATE****

I might know what the problem is - my volume pedal. When it is fully engaged (down as far as it will go), it produces a low signal, however when i push down on the pedal, it becomes louder and produces a seemingly 'proper' signal. is there anyway to recalibrate the volume pedal?

thanks

HD400 - Amps not working at all

support@line6.com — Wed, 12 Dec 2012 09:08:16 GMT

Hey everyone,

I bought my HD400 a week ago and have really started to love using it, so i decided to perform the firmware update to 2.0. Ever since I've done this, none of my presets work anymore and neither do new presets. All of the amps are producing an incredibly weak signal which, when turned up really loud on my mixer, aren't sounding like they did before the update. the only way i can get an amp to work at a proper volume is if i download a pre-made patch, and use that. This is really frustrating me! i think it's because of the firmware update, but i'm not sure. has anyone else had this issue? any help would be great!

p.s. sorry if it's a noob question!

thanks!