Community: Message List - Acoustic sounds routing

Re: Acoustic sounds routing

support@line6.com — Thu, 14 Mar 2013 08:33:39 GMT

Soren, when you do it this way what physical out put do you use to go to the P.A? Is it the XLR?

Also, do you know if there is a patch in the Custom Tone Library that does this for you?

Re: Acoustic sounds routing

support@line6.com — Mon, 04 Mar 2013 13:58:07 GMT

I just ommit the amp completely on acoustic patches. Then there will be no sound routed to the DT25 even though it is connected. On electric patches I set the mixer after the amp to zero volume. That will turn off sound to the PA and only route the sound to the DT25.

I've also created a second bank of patches with the only difference that the volume is not turned down in the mixer after the amp. I use that for playing without the amp if I don't want to drag it along. Then I get all the sound through the PA using just the JTV and the HD500.

Good luck with the programming.

Best regards

Soren

Re: Acoustic sounds routing

support@line6.com — Mon, 25 Feb 2013 05:29:00 GMT

Here are photos of the 2 tones. You'll notice that any effects after the amp need to be on one path otherwise any effects after the amp come through left and right outputs

Re: Acoustic sounds routing

support@line6.com — Tue, 08 Jan 2013 07:18:26 GMT

I agree with msttomservo, FX loop is IMHO best way to go. You can also have regular pickups - electric guitar going to DT25 and piezos - acoustic guitar going to FX loop at the same time using dual signal path - just use fx loop in path with acoustic guitar. With propper settings you can blend those two sounds or do nice and fast changes from eletric to acoustic sound.

Re: Acoustic sounds routing

support@line6.com — Sun, 06 Jan 2013 15:43:17 GMT

I have the same rig and I followed the answer provided about using he FX loop in this post and it worked fine:

http://line6.com/support/thread/89929?tstart=0

Acoustic sounds routing

support@line6.com — Sun, 06 Jan 2013 14:35:46 GMT

Hi, I have a DT25, HD500 and a JTV59. Can anyone recommend a good way to route the acoustic guitar sounds to the PA from either to HD500 or the amp?

I want to switch a patch from an electric sound through the amp to an acoustic sound through the PA. Changing patch is no problem so not expecting to do it within the patch.

Thanks.