Community: Message List - how can I quickly dial in FX parameter values

Re: how can I quickly dial in FX parameter values

support@line6.com — Fri, 25 Jan 2013 11:19:59 GMT

Then yeah, you probably have a problem with your pod.
Don't know about FS1, but the other problem could be due to a faulty firmware update.

Have you tried reflashing it?

Re: how can I quickly dial in FX parameter values

support@line6.com — Thu, 24 Jan 2013 14:02:44 GMT

I don´t think so, the parameter goes in the opposite direction, or better: always toward lower values. I am beginning to susspect it is a problem of my POD (the switch FS1 also has difficulties......

Re: how can I quickly dial in FX parameter values

support@line6.com — Thu, 24 Jan 2013 14:00:04 GMT

im my case the parameter value goes in oppisite direction

Re: how can I quickly dial in FX parameter values

support@line6.com — Wed, 23 Jan 2013 13:19:03 GMT

That's the intended knob behavior, Gerrit.
Maybe it takes a little time to get used to, but it works fine for me though.

Re: how can I quickly dial in FX parameter values

support@line6.com — Wed, 23 Jan 2013 11:37:27 GMT

There has always been 'acceleration' on the POD knobs ... the faster you turn them, the larger the change of values. Don't forget you can also set most values directly using HD Edit if it really gets your goat.

how can I quickly dial in FX parameter values

support@line6.com — Wed, 23 Jan 2013 11:33:59 GMT

Since my last update of my PODHD500 (flash memory 2.10) quick clockwise turning of knob 4, to dial in a higher value of an effect parameter, results in lower values or even zero. Does anyone have the same problem? Or better, is there a way to avoid this other than just slow dialing?