Re: About to buy/link a Dt25 to go with my HD 300. Anything I should know to get it right?

support@line6.com — Sat, 26 Jan 2013 15:57:06 GMT

Read the manuals

Use an AES/EBU cable to connect the two

Use pre amp models

Buy the right interface to update the amp's firmware and use the m-audio driver not the generic one installed automatically

While this is no where near everything it will get you started. It might be better to ask the same question in the DT50/DT25 forum.

About to buy/link a Dt25 to go with my HD 300. Anything I should know to get it right?

support@line6.com — Sat, 26 Jan 2013 05:58:18 GMT

I get my amp shortly and already have a 300.

I'm really looking forward to linking them and really trying to get the best out of the, both.

Is there anything I should know to get the best result?? Ie. turn off amp models or cab sims or output modes etc etc.

I tried one out in a shop together a while ago and wasn't impressed - but I admit I didn't know what I was doing and didn't put enough time in.

Cheers.