Community: Message List - How 2 pan an input with a stereo monitor pair?

Re: How 2 pan an input with a stereo monitor pair?

support@line6.com — Fri, 15 Feb 2013 08:02:22 GMT

Thank you. It's too bad because I wanted to recreate in my IEM the environment I have on stage. For instance I wanted to pan the other singer a bit to my left and my own voice in the middle without changing what the audience hears...

I think panning in the front PA and the stereo monitors should be independant, just like volumes, or there should be a function to make it so.

Re: How 2 pan an input with a stereo monitor pair?

support@line6.com — Thu, 14 Feb 2013 19:27:29 GMT

Hi,

When you use a stereo monitor output the pan does the same sa in the main mix. If you have a channel panned left in your main mix it will be panned left in the monitor. If you have a stereo input channel it will be panned left- right etc.

Cheers,

Arne

Re: How 2 pan an input with a stereo monitor pair?

support@line6.com — Thu, 14 Feb 2013 16:53:52 GMT

I am not near my M20d to test this, but my interpretation of the manual page 3-12 (Monitor Settings) suggests that you would do this by adjusting either the Send or Output levels of the selected Channel in Deep Tweak mode with Monitors selected for the display. With both monitors displayed and available for the selected Channel (the manual shows Female Lead) I would try setting the Output levels for the 2 monitors differently, to reflect your desired panning.

How 2 pan an input with a stereo monitor pair?

support@line6.com — Thu, 14 Feb 2013 15:38:39 GMT

Hi,

I created a stereo monitor for my IEM system but how can I pan an input more left or right in it? Thank you.

Cheers