Skip navigation

This is an archived version of the document. The current version can be viewed here.

Currently Being Moderated

Variax Reflash and Software update F.A.Q.

VERSION 7  Click to view document history
Created on: Oct 26, 2009 3:43 PM by Line6Andy - Last Modified:  Apr 17, 2012 3:12 PM by Line6Hugo

Q:  How do I update or re-install the flash memory on my Variax Electric 300, 500, 600, 700 and James Tyler Variax guitars?

 

A: These instruments can only be returned to factory reset by reinstalling the flash memory. You will need to connect your Variax to the workbench software using your Variax enabled hardware (i.e. Variax Hardware interface, POD XT/X3 Live, POD X3 Pro, VETTA with VDI, or POD HD500), then you will have to connect your interface to your computer via USB.  Once the guitar and interface are connected to the computer, you will need to run Line 6 Monkey.  See the following link for more information on connecting your device to your computer and installing Line 6 Monkey:

 

Line 6 Monkey Installation and F.A.Q.USB Connectivity with Line 6 Devices

 

Once you have Monkey installed and your computer is recognizing the connection, see the screen shots for the reflash procedure:

 

1) Once you run Line 6 Monkey, Monkey may ask you to register.  If you do not wish to register (or have already registered) select "remind me later".

 

1.JPG

 

2) If you want to reinstall the factory presets (or update the firmware), select "Flash Memory" the select "Reinstall Latest"

 

3.JPG

 

3) Select "OK" to agree to the software license

4.JPG

 

4) Select "yes" or "no" If you want to keep the patches on the instrument

5.JPG

 

5) Select "Yes"  to continue with the update.  Do not disconnect the variax during the update.

6.JPG

 

6)  Line 6 Monkey will reinitialize the device and update the flash memory. You can watch the progress on the blue bar on the right side of Monkey.

7.JPG

8.JPG

 

7) Once the update is complete you will need to select "OK" to continue.

9.JPG

 

Variax Bass 700/705 Reflash

Factory defaults must be restored one at a time. Select the Model you wish to normalize, the place the blend and two tone controls in the detent (center) position. Now press the Model select pot down until the indicator light stops flashing. The Model should now be restored to factory settings. Use this procedure for any model you want to restore to the factory setting.  The Variax bass series can also be "reflashed" using the procedure for the Variax electric guitars described above.

Comments (0)