Currently Being ModeratedAug 25, 2011 6:01 AM (in response to fabrizio70)Re: problem with XLR outputs
That can happen if you are using a patch/preset that includes a delay FX set to half a second.
If it is happening with all presets, even with no FX delay assigned, there is a problem. Please provide more information about your setup.
Currently Being ModeratedAug 25, 2011 1:37 PM (in response to fabrizio70)Re: problem with XLR outputs
The xlr's do not sum to mono on the HD500 if only using L or R connector. You could possibly only be hearing one side of the stereo signal. I discovered that when trying to go direct to PA with xlr. I have since purchased a xlr Y cable to combine L/R into one mono/xlr going to board.
Currently Being ModeratedAug 26, 2011 2:52 PM (in response to fabrizio70)RE: problem with XLR outputs
+1 to both Silverhead and jeffster.
You should not be experiencing a 1/2 second delay when using the XLR outputs from the HD500. This could be due to a delay as was mentioned earlier.
Lastly I recommend connecting to other gear and testing all of the outputs to troubleshoot further.
Currently Being ModeratedAug 27, 2011 1:46 AM (in response to fabrizio70)Re: problem with XLR outputs
I suggerimenti degli altri sono corretti -- la risposta secca e' "no", non e' normale. Puo' capitare solo se (guasti esclusi) la patch che stai usando e' configurata proprio cosi'. In particolare, e' vero che se usi uno solo degli output XLR, hai solo il lato destro o sinistro del segnale (mentre se usi una sola uscita jack, il segnale viene miscelato in mono). Se la tua patch da un lato ha un segnale ritardato piu' forte del segnale diretto (ping pong delay o simili), puo' capitare una cosa del genere. Puoi verificare se e' questo il caso usando delle cuffie ed ascoltando solo uno dei canali.
Il fatto che gli XLR siano solo stereo e' una seccatura, perche' spesso dal vivo preferisco avere un segnale mono. In questi casi uso una semplice DI passiva collegata ad una delle uscite jack.
Currently Being ModeratedSep 1, 2011 2:19 PM (in response to fabrizio70)RE: problem with XLR outputs
This ticket is being closed due to lack of response within 48 hours. If you still have questions or are still experiencing an issue please start a new thread and mark the discussion as a question. To do so you can follow the link below and Ask a Question:
For more information about using the Online Technical Support System please review our FAQ at the link below:
Currently Being ModeratedSep 2, 2011 2:31 AM (in response to fabrizio70)Re: problem with XLR outputs
It strikes me that you have your HD500 connected to your computer maybe and the half second latency is being caused by the use of a non-low-latency driver or a larger than necessary buffer setting. With the computer disconnected from your HD500 you should not experience any latency between your guitar input and your monitor speakers.