Currently Being ModeratedNov 20, 2011 7:35 PM (in response to hchoo)Re: How to call up a preset on HD Pro using the new Enhanced Midi Control?
I found this in the appendix C of the Advanced Users Guide, but it's not clear to me... It looks like one would need to call up both the setlist and the preset at the same time? not so sure how to go about doing that....
Bank & Program Change Messages
POD HD Pro will respond to incoming MIDI Bank & Program Change messages as follows.
- Load Set List: from your MIDI controller device, send a Bank Change CC0 (Bank MSB), CC32 (LSB) message with a value of 0 (for Setlist 1), 1 (for Setlist 2), etc., followed by a Program Change message (Value 0-63 for Preset 01A - 16D) for the desired Preset within the Set List. The Set List and Preset are loaded on POD HD Pro.
- Load a Preset within the current Set List: Send a Program Change message (Value 0-63 for Preset 01A - 16D) for the desired Preset within the current Set List.
I wonder if they could come up with a table just like this one from Pod XT Pro's Manual.. Can anyone post an example just like appendix B from the Pod XT Pro?