Currently Being ModeratedAug 25, 2012 10:24 AM (in response to discoian)Re: Line 6 V35 odd behaviour...signal
The V35 out of the box runs in RF2 mode. In this mode you MUST know if wi-fi is operating in your area and pick appropriate channels to go with it. There also exist the possibility that there can be no channels open. Have you measured to see if there is any wi-fi operating in the area. There usually is even if it's not under your control.
Just switch your V35 to run in RF1 mode and it will work like the V30. If you try to use both the V30 and V35 (switched into RF2 mode) there's a good chance that one or both of them won't work.
Currently Being ModeratedAug 25, 2012 2:35 PM (in response to dboomer)Re: Line 6 V35 odd behaviour...signal
For a bit more of the background behind Don Boomer's typically concise and accurate reply, you may find a full read-through of this old discussion informative (its initial topic having been the RF1 frequency scheme vs the newer RF2) as it goes on to address more than one of the issues you've recently mentioned in various threads.