Skip navigation
Up to Discussions in DT50/DT25
148 Views 1 Reply Latest reply: Dec 23, 2012 4:28 PM by Inerzia RSS
Finewest Just Startin'
Finewest
13 posts since
May 9, 2010
Currently Being Moderated

Dec 20, 2012 7:33 PM

DT25 Combo Speaker Settings

I would like to use my new DT25 combo speaker with a cab also attached; can I? My cab is a Line 6 stereo cab with 4 speakers (slant) and has connection options for 8 ohms for stereo, or a single 4 ohm connection for mono. Can I leave the combo's 8 ohm speaker connected while I also connect the 4 ohm cab? Or do I have to disconnect the combo's speaker first? Thanks! (I hate ohms!)

 

ps... I've had the DT25 combo now for about a couple of weeks and OMG! This is the future boys! The blending of tube and modeling is seriously cool! I also have a Line 6 POD HD Pro linked in and it's going to take a lifetime to explore all the tonal possibilities. Really enjoying it!

Tags: speaker, combo, connnection, dt25, dt-25
  • Inerzia Just Startin'
    Inerzia
    54 posts since
    Feb 10, 2007
    Currently Being Moderated
    Dec 23, 2012 4:28 PM (in response to Finewest)
    Re: DT25 Combo Speaker Settings

    All relevant info is printed on the back of the amp, just below the powered output jacks.

    It's A, B or C, and they're mutually exclusive, so, no combinations allowed.
    You can, however, pair speakers or enclosures with the same impedance:

    • Four ohm out (A), admits one four ohm load or two eight ohm loads
    • Eight ohm out (B), admits one eight ohm load or two sixteen ohm loads

    I hope this helps.

More Like This

  • Retrieving data ...

Bookmarked By (0)

Legend

  • Correct Answers - 5 points
  • Helpful Answers - 3 points