The problem is that when you switch models it switches both the A and B signal paths so you can't change your instrument signal path without changing your microphone signal path.

The other problem with the setlists is that when you switch the models it takes time for it to change and the other signal path cuts out.  My guess is there is no way to do this.  Sooooooo this would be a good enhancement for the next release.  Not only would it be great for playing live but it would also be great for recording.  Think of a solo artist being able to bring their Pod Farm device, a laptop and a small PA to a gig and get guitar effects and vocal effects that they can control from their FBV as they are playing. 

Until then I guess I have to build signal chains that I can turn pedals on and off with and not have to change the full signal path.  I guess I have to keep an amp for the whole song

By the way is there a place to get more presets for Pod Farm like there is for the amps?

Thanks!

Since I have the UX8 don't I already have all of the model packs?  If not which ones would I be missing?

So I was playing with some of the setups from custom tones and happened to load one that loaded a dual tone in Pod Farm 1.  In Pod Farm 1 the paths are separate and can be changed one by one.  If only Pod Farm 1 had midi support!   So is there a Pod Farm 1.5 that retained the separate windows for the 2 paths but also enabled midi?