Skip navigation
Up to Discussions in POD HD
280 Views 1 Reply Latest reply: Nov 20, 2011 7:35 PM by hchoo RSS
hchoo Just Startin'
hchoo
19 posts since
Oct 24, 2007
Currently Being Moderated

Nov 20, 2011 4:21 PM

How to call up a preset on HD Pro using the new Enhanced Midi Control?

How can I setup an external foot controller such as Liquid Foot (not FBV footswitch) to call up presets?

 

When I used the Pod XT Pro, on the back of the manual there was a list of Midi program changes list and it was very easy to call up:

 

Pod Channel         -          Midi Program Changes

1A                                                  0

1B                                                  1    

1C                                                  2    

1D                                                  3

2A                                                  4

2B                                                  5

2C                                                  6

2D                                                  7

etc..                                             etc..              

etc...                                            etc..

 

Now with the HD Pro setlist implementation, I'm not sure how it would work out as there will be 8 x 1A, 2A, 3A etc... within 8 different setlists...

 

In the Midi Assign section on the Pod HD Pro Edit, how would one setup in a way that the preset is controlled by an external controller other than the FBV Footswitch?

 

http://i44.tinypic.com/2585x20.jpg

 

Midi Assign.jpg

Tags: pod, control, midi, preset, hd, pro, enhanced
  • hchoo Just Startin'
    hchoo
    19 posts since
    Oct 24, 2007
    Currently Being Moderated
    Nov 20, 2011 7:35 PM (in response to hchoo)
    Re: How to call up a preset on HD Pro using the new Enhanced Midi Control?

    I found this in the appendix C of the Advanced Users Guide, but it's not clear to me... It looks like one would need to call up both the setlist and the preset at the same time? not so sure how to go about doing that....

     

    Bank & Program Change Messages

    POD HD Pro will respond to incoming MIDI Bank & Program Change messages as follows.

    • Load Set List: from your MIDI controller device, send a Bank Change CC0 (Bank MSB), CC32 (LSB) message with a value of 0 (for Setlist 1), 1 (for Setlist 2), etc., followed by a Program Change message (Value 0-63 for Preset 01A - 16D) for the desired Preset within the Set List. The Set List and Preset are loaded on POD HD Pro.

     

    • Load a Preset within the current Set List: Send a Program Change message (Value 0-63 for Preset 01A - 16D) for the desired Preset within the current Set List.

     

     

    I wonder if they could come up with a table just like this one from Pod XT Pro's Manual.. Can anyone post an example just like appendix B from the Pod XT Pro?

     

    http://i44.tinypic.com/oapy54.jpg

     

    midiprogramchanges.jpg

More Like This

  • Retrieving data ...

Bookmarked By (0)