Currently Being ModeratedMar 4, 2013 12:27 PM (in response to fonz182)Re: M13 not going into the FX-Loop ? 4-CM. HELP !
First thing is go for the simplest solution.
1. Check your scene settings and verify that the modulation effects are routed where they should be.
2. If that fails, get yourself some contact cleaner with lubricant (available at Radio Shack) squirt it in the output jacks and run a plug a few times, perhaps there is some gunk in it and they do get stuck in time.
3. If these 2 don't work, it could be a jack failure. If you had your M13 effects set up properly (modulation in loop) but didn't plug anything to the effect loop jacks, then it would route everything through the input.
Currently Being ModeratedMar 4, 2013 3:22 PM (in response to echoraven)Re: M13 not going into the FX-Loop ? 4-CM. HELP !
I agree, make sure the effects loop is after effect 1 and before 2,3 and 4. It sounds very much like that is the problem so the delay is going before the pre amp rather than in the amp's effects loop.