henrykc

datacommando: thank you so much:)

So I decided to click on "Back to HX Edit", it sows firmware 2.91. I turned off the HX Stomp and when I turned it on it shows firmware 2.91 but I was expecting to see new factory presets and it still shows my old presets with my own IRs. Does it mean that I don't need to restore my backup that I did before installing firmware 2.91? Please confirm, Thank you:)

I got a message from HX Edit that my update is complete but I don't see on the unit any activity for Presets Library being rebuild, HX Edit says that it should take a few minutes. I have been waiting for more than 30 minutes and I am afraid to turn it off or I am afraid to click on HX Edit "Back to HX Edit." Should I wait longer?

Thank you! I was leaning to keep delay and reverb after HX Stomp. With 6 blocks available only, and I want to run in stereo, I could use 4 blocks for (2 amps, 2 IRs), and two blocks left maybe for booster and overdrive/distortion.

Thank you so much!

Thank you!

Dear HX Stomp users, I am ready to purchase my HX Stomp and I have two questions, I hope somebody can help me: (1) Real tube amp has preamp, power amp, and speaker. I want to use my tube preamp Kingsley Constable pedal which is based on Marshall Plexi. So, I don't want to use amp modeling in HX Stomp but only power amp modeling and I.R. cab simulation. In amp models in HX can I use only power amp section and not to use preamp section? (2) I plan to use my external stereo delay and reverb pedals, sound-wise, is it better to use them in HX Stomp FX loop or just place them after the HX Stomp? Placing them after HX Stomp would give me more blocks available but my decision would be based on sound. Thank you, Henry

I hope somebody can answer my question. I am ready to buy HX Stomp. I want to use my Strymon BigSky Reverb in Stereo, sound-wise what is better to place BigSky after HX Stomp or in its FX loop? Thank you, Henry

Maybe somebody could answer my question. I am getting ready to purchase HX Stomp. Real tube amp has preamp, power amp, and speaker. I want to use my dual tube preamp Kingsley Constable pedal which is based on Marshall Plexi. So, I don't want to use amp modeling in HX Stomp but only power amp modeling and I.R. cab simulation. In amp models in HX can I use only power amp section and not to use preamp section? Thank you, Henry

I have the same problem, my XLR line out does not seem as it should. I also did reset to factory settings but still it sounds horrible. Maybe I should tryDT Edit software to see if microphone emulation is turned off. Any advice? Thank you, Henryk