Wondo100

Ok. So, I have had the Helix for a couple of months now and have been able to successfully hook up two H&K Grandmeisters to the Helix with 7CM. I have a few qestions. 

How can I stop bleed over to one of the Effects loop as a preamp when it is turned off? 

How can I set up the volume properly? When I turn the master volume of the Helix it gets really loud into the amp which overrides what the normal volume of the amp would be. (There is no Loop input control on the Grandmeisters, just simple series loops). 

Should I set up all inputs and outputs as instrument? Where do I find that?

If I want my two amps to go back and forth with delay repeats, how do I do this with 7CM?

Have not even begun to dig into how to get the channel changes with MIDI yet and how to do control commands for the amp. 

Thanks. 

Think I figured it out by choosing send 1 and send 2 with no returns and then I can use the Helix preamp. 

This is very helpful. The problem I am running into now is how to have everything hooked up in 7CM and then if I want, use the amp models as the preamp in the helix to just use the power amp on my guitar amp. Thus, being able to either use my amps preamp or the Helix. I cannot figure out how to do this. I have tried different paths and assignments to the loops with no luck.

Thanks. I still have a lot to learn with this. So, I could use one path and have everything in Stereo without creating a second path and this path would go to both amps?

I have seen this topic in a couple of places, but yet I do not hear much from anyone using 7CM. I have two H7K Grandmeisters and want to run the Helix into those so that I can get some true stereo effects. I am not exactly sure how to do that (how can I get the effects to be stereo into both amps in the signal chain/) Also, I want to make sure that in certain settings I can use only my H&K preamps but in others be able to use the modeling from the Helix as my preamps and not use the H&K preamps. 

Thanks.